High Lifter Can-Am Defender Riser Snorkel Kit (2016-19)

The High Lifter Riser Snorkel Kit for 2016-2019 Can-Am Defender Models. High Lifter makes the highest quality and most comprehensive snorkel kits in the ATV/UTV industry. This High Lifter Snorkel kit contains everything you need to properly snorkel your ride. 

Store Wide Sale! Save 5% to 15% at Checkout on 1000's of products. 

Custom Powder Coated Riser Bracket to keep risers straight, evenly spaced and looking good. 

There are no returns or refunds on any brand of snorkel - All Sales Final. 

Features:
Rubber Grommets to hold riser tubes in place.
1 ½”, 2” or 3” Risers - based on specific model.
Heavy Duty Vinyl Tubing to route difficult locations where the competition uses think tubing.
High Heat Silicon Hose in those critical areas where the competition melts.
Bellows to keep water out of differentials and transmission.
All mounting hardware for complete installation.
Step-by-step instructions complete with detailed photos. 

Note: Does not work on CAB models or units with a Back Glass Window.

Note: You have to cut/trim some plastic to install this kit.

Benefits:
Provides clean, dry air to the engine and other parts needing venting.
Prevents mud, water and debris from entering the engine and clutch housings when equipped
Bellows allow the differential and transmission air to expand and contract without the need for long vent lines that can easily get plugged with mud or be pulled off.
Each Kit is engineered and cut to fit your specific application.

Snorkels leak for a variety of reasons. Installation errors account for a lot these. Many times, a do-it-yourselfer may get it right, but only for a short time. When pipes aren’t cut to correct length and things don’t line up quite right, many times the snorkel will prevent water, but only for a limited time, then the joint fails. One of the most common that we’ve seen is failure due to a heat source. When the snorkel runs close to heat source the snorkel material deteriorates during each ride. The material gets harder and more brittle, and many times begins to deform. At some point the material cracks and begins to let mud and water in. Less expensive kits rarely provide the heat resistant material to account for this. Our goal is to avoid these areas. This can take more time and more material but goes a long way to extending the life of the snorkel and the ATV/UTV.